Heater/Furnace 290,000 b.t.u. Oil Fired Heater, Kerosene or Diesel Fuel
Minimum $77 /2-hours
Dept.038 | Cat. 0080
Unit holds 26 gallons of fuel and will run for 13 hours on one tank.
Use #1 fuel oil or kerosene only. Kerosene is additional and extra 5 gallon cans are available.
To estimate b.t.u.’s needed: cu. ft. x .133 x temperature rise
A two car garage is about 20'x 40'x 10'= 8,000 cu. ft.
8,000 x .133 x 40= 42,560 b.t.u.’s needed to raise the temperature 40 degrees.
This Indirect Fired Heater by Heat Wagon is the ideal choice for any medium to large industrial application. This oil-fueled heater produces clean, dry heat. The Four-Loop Exhaust System ™ helps produce the clean, dry air by providing higher efficiency while in use. The heater runs on #1 or #2 diesel, kerosene, JP-8 or Jet-A fuel. With an output of 2,500 CFM, this heater will have a temperature rise of 160 degrees F. With its two wheels and handle, this heater has one-man maneuverability! This unit is ductable up to 50 feet, allowing warm air to be spread around evenly. The 26 gallon fuel tank delivers up to 16 hours run time!
The Heat Wagon IDF Oil Fired Heater, has an output of 290kBTU/HR. It runs on a 15 amp circuit, which means low-power consumption. The heater weighs 270 pounds when empty. The dimensions (L X W X H) are 69” X 28” X 38”. includes optional thermostat, which allows constant temperature control between 30-110 degrees F. This heater is CSA approved.
- Indirect Fired Oil Heater
- Produces Clean, Dry Heat
- Optional Remote Thermostat THIDF
- Ductable Up to 50 Feet
- 26 Gallon Fuel Tank
- 13 Hour Run Time
- Runs on 120 Volt 12 Amp Circuit
- Runs on 1# or #2 Diesel, Kerosene,
- JP-8 or Jet A
- Output of 2,500 Cfm
- Temperature Rise of 160 Degrees F
- CSA Approved